Deprecated: Function get_magic_quotes_gpc() is deprecated in /home/customer/www/ on line 46

Deprecated: The each() function is deprecated. This message will be suppressed on further calls in /home/customer/www/ on line 22

Warning: session_set_save_handler(): Cannot change save handler when headers already sent in /home/customer/www/ on line 56

Warning: session_name(): Cannot change session name when headers already sent in /home/customer/www/ on line 144

Warning: session_save_path(): Cannot change save path when headers already sent in /home/customer/www/ on line 173

Warning: session_set_cookie_params(): Cannot change session cookie parameters when headers already sent in /home/customer/www/ on line 141

Warning: session_start(): Cannot start session when headers already sent in /home/customer/www/ on line 97

Warning: extract() expects parameter 1 to be array, null given in /home/customer/www/ on line 195
Relay Insert 2 * 1.5 KW, Shifra Smart Homes Shop


Relay Insert 2 * 1.5 KW

Relay Insert 2 * 1.5 KW
The Fibar insert is designed to be placed into a pattress box behind the traditional switch. This switch is then not longer controlling the electrical load directly but acts as input device for the insert. The insert has an internal relay to control the electrical load attached. With product an existing installation can be turned into a Z-Wave enabled smart system keeping the original switches in place. This is particularly important if these switches belong to a special switching series where no Z-Wave enabled replacement is available.

However the pattress box need to be deep enough to accommodate the insert and the traditional switch.  The insert is 15 mm high so a minimum depth of about 50 mm is required to install the product.
Technical Data:
  • Power Source 110 V … 230 V, 50..60 Hz
  • Max. AC output: 2*8 A/ 230 V
  • Max. DC output: 2 *8 A/ 30 V
  • Max. Power load 2*1.5 KW as resistive load ( in case of loads other than resistive it may be necessary to connect lower output in order to protect the Switch from damage)
  • Conforms to UE requlations: EN55022 (radio wave interference), EN61000-6 (safety of use),
  • Overheating protection: safety off at 105oC,
  • Ambient temperature: 10oC - 40oC
  • To be mounted in standard wall switch boxes fi ≥50mm,
  • Radio protocol: Z-Wave, Radio Frequency 868 MHz,
  • Antenna range: up to ca. 50 meters outdoor, or up to 30 meters inside (depends on building structure),
  • Outside dimmensions (L x W x H) 42mm x 36mm x 15mm.
  • This product will be in stock on Tuesday 01 January, 2030.

Quick Find
Use keywords to find the product you are looking for.
Advanced Search
We Accept
0 items
Manufacturer Info
Fibaro Homepage
Other products
Share Product
Share via E-Mail
Share on Facebook Share on Twitter